05-03-2013 09:30 PM - edited 03-04-2019 07:48 PM
Hello,
I have a 2811 router that I need to confirm NAT configurations as expected. I have 2 deviced on the internal LAN that need to access remote resources without PAT. All the other devices are for a guest network with PAT. My interface Fa0/0 is connected to local network (1.1.1.1/23). Fa0/1 is connected to ISP (10.10.10.178/30). Addressable range from ISP of 10.10.10.192/28 (10.10.10.193-10.10.10.206). Internal machine 1.1.1.2 & 1.1.1.3 must connect to a remote server through internet on spacific port numbers. Attached is the configuration I have.
Solved! Go to Solution.
05-04-2013 08:59 AM
Hello Cody,
It would be easier if you just configure static NAT.
ip nat inside source static 1.1.1.2 10.10.10.193
ip nat inside source static 1.1.1.3 10.10.10.194
no ip nat pool static1 10.10.10.193 10.10.10.194 prefix-length 28
no ip nat inside source list 2 pool static1
no ip nat inside source list 3 pool static1
Local devices 1.1.1.2 and 1.1.1.3 wil be visible from internet as 10.10.10.193, 10.10.10.194 respectively.
Best Regards
Please rate all helpful posts and close solved questions
05-04-2013 08:59 AM
Hello Cody,
It would be easier if you just configure static NAT.
ip nat inside source static 1.1.1.2 10.10.10.193
ip nat inside source static 1.1.1.3 10.10.10.194
no ip nat pool static1 10.10.10.193 10.10.10.194 prefix-length 28
no ip nat inside source list 2 pool static1
no ip nat inside source list 3 pool static1
Local devices 1.1.1.2 and 1.1.1.3 wil be visible from internet as 10.10.10.193, 10.10.10.194 respectively.
Best Regards
Please rate all helpful posts and close solved questions
05-04-2013 12:25 PM
Exactly what I needed. Thanks a lot!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide