Routing

Hello,help me pls, how long takes bgp to install new best routes(FULL VIEW) to routing table if i reset my primary neighbor. I have second neighor with AS-PATH PREPEND. I need to know will be break in routing or not.

Hi i have a  WS-C4006 switch.It hasIOSCAT{System Bootstrap Version: 5.4(1)}.I need to upgrade CATIOS in to ciscoIOS.Can anybody give me the steps???thx

                   I am looking for a solution to test backup links for my routers, without having to shutdown primary link.... We are using primarily BGP and EIGRP protocols and most of our backup links are VPN tunnels. Other than using passive inte...

Hi, i am dealing with a network problem. Any ideas will be helpful.Thanks.    

Dear Folkz,I've 50 users in my lab., all of them are accessing internet via a NAT router., I want to get a report of internet usage per ip from my NAT router.? How can i do that..?  Is there any possibility any way??

I have a GRE over IPSec tunnel between two locations.  Here is the following output I have a question about:router1#sh crypto isakmp saIPv4 Crypto ISAKMP SAdst             src             state          conn-id statusa.a.a.a    b.b.b.b     QM_IDLE   ...

hey guys thanks for looking at my post, i have been setting up internal networks nothing hooked up to the net, but now i want to hook up to the net and need some guidence. my set-up so far is just fairly simple to test for connectivity.i took out my ...

Headline

  I have a client that is building a product based upon the Cisco 5915 board.  This product will need to be tested and they want to use Router IP Traffic Export (RITE) to meet that requirement.According to the RITE documentation, IP traffic capture i...

Hi All,   I am trying to configure MLoFR and want to bundle two serial links as multilink. Please refer the configuartion at my end router terminating both P2P serial connectivity with ISP.interface Serial0/0/0no ip addressno ip redirectsno ip unreac...

Hi All.I'm having a bit of a nightmare trying to get the VDSL interface to work on my 887 router.  It was working just fine on standard ADSL but now i have moved over to VDSL i cant seem to get it connected.  When i connect the RJ11 into the back of ...

I need to setup a network infrastructure for AMI. Automated Metering Infrastructure.I am reading from various documents to learn more,but I wanted an opinion from someone who implemented AMI and has experience with it.Has anyone implemented this tech...