Need to configure Power supply redundancy

[Tijo John]

Hi,

I have attached Show power and Show module command out put of Cisco7609 router. Could you please confirm can we do the power redundancy?

Now the router  is working in Power combined mode.

[Vinit Jain]

Hello

Yes, based on the logs, i dont think there should be any problem to enable power redundancy.

http://www.cisco.com/c/en/us/td/docs/routers/7600/ios/15S/configuration/guide/7600_15_0s_book/pwr_envr.html#40037

To enable redundancy, use the redundant keyword. In a redundant configuration, the total power drawn from both power supplies is not greater than the capability of one power supply. If one supply malfunctions, the other supply can take over the entire system load. When you install and power up two power supplies, each concurrently provides approximately half of the required power to the system

To enable redundancy, you can use the command power redundancy-mode redundant

Hope this helps.

Regards

Vinit

PS: Please mark the question as answered if your query has been answered.

[Tijo John]

Dear Vinit,

Thank you very much for your reply