cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1500
Views
5
Helpful
9
Replies

No show DMVPN

livi9003
Level 1
Level 1

I have DMVPN working on 7 routers all are 4331 with 16.9.5. I am using NHRP but not crytop

 

 

All is working well, But when I try to "Show DMVPN"  I get invalid input after the d

 

I ideas?

Again DMVPN is work with a dynamic tunnel spoke to spoke when needed, just no sh dmvpm.

 

Thank you

9 Replies 9

Hello,

 

do you see anything with:

 

show ip nhrp nhs

nhrp Registration Timer: 20 Sec

Deepak Kumar
VIP Alumni
VIP Alumni

Hi,

What is the output you are getting? Can u post here?

 

I think you will get something like:

 

Router# show dmvpn
Legend: Attrb --> S - Static, D - Dynamic, I - Incomplete
        N - NATed, L - Local, X - No Socket
        # Ent --> Number of NHRP entries with same NBMA peer
! The line below indicates that the sessions are being displayed for Tunnel1. 
! Tunnel1 is acting as a spoke and is a peer with three other NBMA peers.
Tunnel1, Type: Spoke, NBMA Peers: 3,
 # Ent  Peer NBMA Addr Peer Tunnel Add State  UpDn Tm Attrb
 ----- --------------- --------------- ----- -------- -----
     2      192.0.x.x     192.0.2.116   IKE     3w0d D    
     1     192.0.x.x      192.0.2.11  NHRP 02:40:51 S    
     1     192.0.x.x      192.0.2.10    UP     3w0d S    
Tunnel2, Type: Spoke, NBMA Peers: 1, 
 # Ent  Peer NBMA Addr Peer Tunnel Add State  UpDn Tm Attrb
 ----- --------------- --------------- ----- -------- -----
     1        192.0.x.x      192.0.2.171   IKE    never S 
Regards,
Deepak Kumar,
Don't forget to vote and accept the solution if this comment will help you!

I got  get invalid input after the d

#sh dmvpn

      ^

"invalid input detected at '^'

Hi,

What about the license? You might need a Security license.

Regards,
Deepak Kumar,
Don't forget to vote and accept the solution if this comment will help you!

pboynton1
Level 1
Level 1

did you ever get this sorted????  I am having the exact same issue under similar circumstances

Hello @pboynton1 
Suggest create your own post so it can be troubleshooted , appending the outpout of show version to it


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

Hello,

try and toggle 'ip cef':

4331(config)#no ip cef

4331(config)#ip cef

Kagamigawa
Spotlight
Spotlight

like Deepak Kumar said , you need check your license ,  DMVPN on IOS-XE based router need Security license or higher

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: