cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2937
Views
10
Helpful
2
Replies

OSPF area range

feiyang
Cisco Employee
Cisco Employee

Hello expert,

I am trying to configure an ospf area range to summarize the routes in area 1:

1.1.8.0/24, 1.1.9.0/24, 1.1.10.0/24, 1.1.11.0/24

by using area 1 range 1.1.8.0 255.255.252.0

However, on the other ospf routers in area 0, I can see the summary route 1.1.8.0/22, and also the four /24 routes.

I am using 12.4 image, do I miss anything?

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions

pkhatri
Advisor
Advisor

Hi,

 

How many ABRs do you have between area 0 and area 1 ? If you only configure the

area range

command on one of the ABRs, then the other ABRs will still advertise the /24s.

 

Paresh

 

PS. Pls do remember to rate posts.

View solution in original post

2 REPLIES 2

pkhatri
Advisor
Advisor

Hi,

 

How many ABRs do you have between area 0 and area 1 ? If you only configure the

area range

command on one of the ABRs, then the other ABRs will still advertise the /24s.

 

Paresh

 

PS. Pls do remember to rate posts.

amit-singh
Collaborator
Collaborator

Hi,

 

I think You have done the things correctly. is this configuration done on the router once it alredy had the above listed /24 routes in the database.

 

Is this a test setup. try clearing the routes manually and check if the router still lists them.

 

clear ip route

 

-amit singh

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: