04-09-2015 01:00 AM - edited 03-05-2019 01:12 AM
I see my route 4.4.4.4 is being received and added to the ospf database, but it is not being added to the routing table. Any ideas?
Router#sh ip ospf database
OSPF Router with ID (8.8.8.8) (Process ID 1)
Router Link States (Area 0)
Link ID ADV Router Age Seq# Checksum Link count
8.8.8.8 8.8.8.8 313 0x80000002 0x0042de 0
Summary Net Link States (Area 0)
Link ID ADV Router Age Seq# Checksum
10.10.10.0 8.8.8.8 301 0x80000001 0x0027fb
Router Link States (Area 1)
Link ID ADV Router Age Seq# Checksum Link count
8.8.8.8 8.8.8.8 310 0x80000003 0x000bc5 1
10.10.11.1 10.10.11.1 310 0x80000002 0x00fad7 1
Net Link States (Area 1)
Link ID ADV Router Age Seq# Checksum
10.10.10.2 10.10.11.1 310 0x80000001 0x005a44
Summary Net Link States (Area 1)
Link ID ADV Router Age Seq# Checksum
10.10.11.0 10.10.11.1 306 0x80000001 0x000f13
4.4.4.4 10.10.11.1 306 0x80000002 0x00e447
10.10.12.0 10.10.11.1 306 0x80000003 0x000a14
Type-5 AS External Link States
Link ID ADV Router Age Seq# Checksum Tag
0.0.0.0 8.8.8.8 313 0x80000001 0x002c86 1
Router#sh ip route
Gateway of last resort is 0.0.0.0 to network 0.0.0.0
8.0.0.0/32 is subnetted, 1 subnets
C 8.8.8.8 is directly connected, Loopback1
10.0.0.0/30 is subnetted, 1 subnets
C 10.10.10.0 is directly connected, FastEthernet0/1
S* 0.0.0.0/0 is directly connected, Loopback1
Router#show ip ospf neighbor
Neighbor ID Pri State Dead Time Address Interface
10.10.11.1 1 FULL/DR 00:00:02 10.10.10.2 FastEthernet0/1
Router#
04-09-2015 02:15 AM
Hi,
Lsa type 3 is seen in area 1 as above output.
Based on ospf rfc, abr router will not use lsa tyoe 3 in a non-backbone area.
Regards,
Minh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide