OSPF with IP SLA

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-07-2018 03:39 AM - edited 03-05-2019 10:24 AM
Hi
I have two point to point link on a single router/Switch and using OSPF on the same. Now we have two requirement:
Condition 1: if there is Jitter, delay, packet drops on primary link due to bad link (carrier network issue). Router should track/monitor this situation and take the primary link out of OSPF to switch traffic on another link.
Condition 2: if there are packet drops on link due to over utilization of link, router should continue to use same link and do not fail over.
Kindly share the solution.
- Labels:
-
Other Routing
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-07-2018 04:31 AM
