06-13-2009 07:40 AM - last edited on 03-25-2019 03:24 PM by ciscomoderator
When configuring class-map/policy-map... where will the application command "service-policy in/out XXXX " be applied?
06-13-2009 07:45 AM
Under interface, subinterface, VC, VC-class and the like.
Note that is called MQC and not PBR.
06-13-2009 12:21 PM
Kennie,
It depends, You cannot apply some MQC in the inbound direction(Let's say CBWFQ). You cannot apply MQC directly under the frame-relay sub-interface.
QOS,let's start from here : http://supportwiki.cisco.com/ViewWiki/index.php/Category:Quality_of_Service_(QoS)
In case you are interested in PBR. Here you go : http://supportwiki.cisco.com/ViewWiki/index.php/Category:Policy_Based_Routing_(PBR)
HTH,
Toshi
06-14-2009 10:18 AM
I mean under source int ot output?
06-14-2009 11:38 AM
Can be either or both, it depends on what you are doing.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide