06-30-2013 05:24 AM - edited 03-04-2019 08:20 PM
Hello Guys,
I am testing Cisco 2911 router with 1 pair SHDSL HWIC to connect my service provider static ip ADSL connection.
The router contains adsl_alc_20190.bin firmware. But no idea where to start please help to configure ADSL on SHDSL WIC.
Regards
Sudan
Solved! Go to Solution.
06-30-2013 08:34 AM
SHDSL HWIC does not supports ADSL.
Post "show inventory" to confirm the extact hardware you have installed.
06-30-2013 08:34 AM
SHDSL HWIC does not supports ADSL.
Post "show inventory" to confirm the extact hardware you have installed.
06-30-2013 09:40 PM
Dear Paolo, here is the output of " Show inventory " and clearly says its HWIC-2SHDSL
NAME: "CISCO2911/K9 chassis", DESCR: "CISCO2911/K9 chassis"
PID: CISCO2911/K9 , VID: V07 , SN: FTX1719AKBM
NAME: "2 port SHDSL with annex A,B,F and G on Slot 0 SubSlot 0", DESCR: "2 port SHDSL with annex A,B,F and G"
PID: HWIC-2SHDSL , VID: V01 , SN: FOC17161UR0
NAME: "C2911 AC Power Supply", DESCR: "C2911 AC Power Supply"
PID: PWR-2911-AC , VID: V05 , SN: AZS1712059M
Regards
Sudan
06-30-2013 08:35 AM
Hi Sudan,
Can you please attach following output
1."show tech"
2. show dsl int atm x
3. sh controller atm/dsl
4. was it working fine before
after having a look in more specifics we can narrow down the issue
Thanks
07-01-2013 12:20 AM
Dear Anisaini,
It was not working before i am testing this in my lab.
07-01-2013 01:06 AM
Hope you have gone through the link below
check if the controller is up or down
check if controller is up and if issuw with higher layer protocol
Thanks
07-01-2013 05:06 AM
sudan dhakal wrote:
Dear Anisaini,
It was not working before i am testing this in my lab.
Answered above. Cannot have ADSL with SHDSL interface.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide