06-30-2013 05:24 AM - edited 03-04-2019 08:20 PM
Hello Guys,
I am testing Cisco 2911 router with 1 pair SHDSL HWIC to connect my service provider static ip ADSL connection.
The router contains adsl_alc_20190.bin firmware. But no idea where to start please help to configure ADSL on SHDSL WIC.
Regards
Sudan
Solved! Go to Solution.
06-30-2013 08:34 AM
SHDSL HWIC does not supports ADSL.
Post "show inventory" to confirm the extact hardware you have installed.
06-30-2013 08:34 AM
SHDSL HWIC does not supports ADSL.
Post "show inventory" to confirm the extact hardware you have installed.
06-30-2013 09:40 PM
Dear Paolo, here is the output of " Show inventory " and clearly says its HWIC-2SHDSL
NAME: "CISCO2911/K9 chassis", DESCR: "CISCO2911/K9 chassis"
PID: CISCO2911/K9 , VID: V07 , SN: FTX1719AKBM
NAME: "2 port SHDSL with annex A,B,F and G on Slot 0 SubSlot 0", DESCR: "2 port SHDSL with annex A,B,F and G"
PID: HWIC-2SHDSL , VID: V01 , SN: FOC17161UR0
NAME: "C2911 AC Power Supply", DESCR: "C2911 AC Power Supply"
PID: PWR-2911-AC , VID: V05 , SN: AZS1712059M
Regards
Sudan
06-30-2013 08:35 AM
Hi Sudan,
Can you please attach following output
1."show tech"
2. show dsl int atm x
3. sh controller atm/dsl
4. was it working fine before
after having a look in more specifics we can narrow down the issue
Thanks
07-01-2013 12:20 AM
Dear Anisaini,
It was not working before i am testing this in my lab.
07-01-2013 01:06 AM
Hope you have gone through the link below
check if the controller is up or down
check if controller is up and if issuw with higher layer protocol
Thanks
07-01-2013 05:06 AM
sudan dhakal wrote:
Dear Anisaini,
It was not working before i am testing this in my lab.
Answered above. Cannot have ADSL with SHDSL interface.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: