Really Need Help Here!! RIP V2 & DHCP Server

[sarfarazkazi]

Hi,

I have a multilayer Cisco 3560 network. All sites are connected to each other using RIP V2.

1. We have remote sites connected by microwave links using Cisco 3560.

2. In the attached image "Site-1" should get an IP from the HeadOffice DHCP Server.

3. HEAD OFFICE switch is running the VTP Domain.

Question

1. I have rip version 2 running. How do I get "SITE-1" to get an IP Address from the DHCP Server running in Head Office.

Kindly give me your expert comments/suggestions in how do I go about achieving the above.

Regards

Sarfaraz

[royalblues]

Yes...

That would do

Narayan

[Richard Burts · Accepted solution]

Sarfaraz

I am glad that you are now able to get IP addresses from the DHCP server at HQ. In terms of problems with connectivity outside, it would be helpful if you would post the output of show ip route from the site 1 switch and perhaps also post the output of show ip route from the HQ.

HTH

Rick