Routing

i have a 3600 series router in which i could not boot the system. it comes into rmon mode. im trying to put an ios image through xmodem but it showes me this message kindly advice me how to proceed with this upgradation, i have set the confreg to 0x2...

Hi guys, first up I would like to say thanks for sorting out my dhcp issues in the getting started with LANS part of the forum!I have an issue now with my adsl connection. I have set up the dialer 0 and atm 0 interfaces according to this guide:http:/...

Hi All,I am trying to find the Reference Commands for 7206 but I could not get it from the cisco website. Have tried to search but in vain. Anyone has the idea where i can get a full set of the commands reference for 7206?Thanks in advanced.

I am trying to find out on which interface types 'Connectivity Fault Management" is supported on 2800 and 3800 ISR platforms.I could see 12.4(11)T software version does support this feature on these routers.I am interested in knowing support on Gigab...

Hello all. This is my first posting and I am some what of a novice when it comes to Cisco routers. Could anyone guide me through how to reset my router to how it came out of the box. I am trying to configure it by using SDM but at present it has a mo...

Hi ,Can any one help me to resolve the following problem. While I was induldged in the Network preventive Health Checkup I found that the core (5509)Switch's Supervisor Engine module is show a ABNORMAL indication of LEDs.I could found the Status of...

one of my customer wants a router for Primary site , currently using 2821 router in Primary site

I configured the router which are connecting to 2 different branches. But always i can see the traffic is flowing only through one link only. how can i do a load balancing. The 1st link is 128Kbs and second is 64Kbs. Is it necessay that both the link...

Standby track command it will track serial interface or Ethernet interface?

i have a 3600 series router in which i could not boot the system. it comes into rmon mode. im trying to put an ios image through xmodem but it showes me this message kindly advice me how to proceed with this upgradation, i have set the confreg to 0x2...

Hi,My question is why isn't the 1483 bridged Encapsulation method available for configuring a Router whose client has a static IP. Both myself and collegues have gone through the set up in the SDM software and can't find this option. Are we all missi...

HelloI have 4 different sites which are connected with diginet lines. When these lines go down the routers are meant to automagically open the ISDN lines and dial out to connect the site. The problem is that this has never worked before I joined the ...

When I connect the adsl cable, the CD led gives no signal.The RX/TX led's are flashing very fast.When I do a 'debug atm events', I get :Router#debug atm eventsATM events debugging is onRouter#00:18:53: DSL: 20: Modem state = 0x800:18:56: DSL: Could n...