02-18-2013 07:00 PM - edited 03-04-2019 07:03 PM
Dear Team,
How to enable or check loop on ethernet interfaces as we do in serial links for testing the connectivity between end to end on point to point links.
when do we use the loopback internal command.
Thanks in advance.
Naveen
02-19-2013 12:55 AM
No really needed. Assume the port is working until proven otherwise.
02-22-2013 07:06 PM
Hi Paolo Thanks for the reply,
It's needed when we have an WAN termination in Ether output. So how can we check in this scenarios when we used Ethernet terminations for WAN links.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
