cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
260
Views
0
Helpful
2
Replies
Beginner

Router takes ip sla commands but does not recognize track

Hi,

I have an Cisco 850 router (c850-advsecurityk9-mz.124-15.T17). The router is able to take the following command.

ip route 1.1.1.1 255.255.255.255 2.2.2.2 track 1

It shows up n the running-config

#show run | inc ip route 1.1.1.1

ip route 1.1.1.1 255.255.255.255 2.2.2.2 track 1

However, it doesn't show up in the routing table. If I remove the "track" keyword from the ip route command, then it works and shows up in the routing table. Although "ip sla" command and its sub-commands work, it seems "track" is not there in the global config mode or even in "show track".

Router(config)#ip sla 1 ?

  <cr>

Router(config)#track ?

% Unrecognized command

Router(config)#rtr ?

% Unrecognized command

Is this expected ?

Regards,

Rick.

1 ACCEPTED SOLUTION

Accepted Solutions
Advisor

Router takes ip sla commands but does not recognize track

Hi,

From Cisco Navigator this feature is not available on the 850 platform.

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.

View solution in original post

2 REPLIES 2
Advisor

Router takes ip sla commands but does not recognize track

Hi,

From Cisco Navigator this feature is not available on the 850 platform.

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.

View solution in original post

Beginner

Router takes ip sla commands but does not recognize track

Thanks Cadet, had a look too and couldn't find it for the 850 series.

Regards,

Rick.

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards