show clock rate on DTE?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-13-2007 09:46 AM - edited 03-03-2019 04:09 PM
Hi community,
is it possible to see the clock rate configured on the DCE side on the DTE side of a serial interface?
Regards, Martin
- Labels:
-
Other Routing

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-13-2007 10:15 AM
Yes its possible issue the command:
sh controllers serial x/x/x
on both sides
RE
Kamran
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-13-2007 10:19 AM
Hi,
sure on the DCE side this would show the clock rate. But where do you see the clock rate on the DTE side with "show controller"?
Can you post an example?
Regards, Martin

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-13-2007 11:41 AM
Only certain platforms and cards will show the received DTE clock in "show controller". Others will just say "TX and RX clocks detected".
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-07-2019 03:55 PM
Sample output on my 1941 router:
The number shown is 1917381 +/- 10%.
Which would imply a clock rate of 2000000.
My answer is a little late to the party, but maybe this will help the next person as the existing answers did me.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-28-2019 12:24 AM
Regards
Dheeraj.
