hi all, i had set two users in cisco 3850 and 3650 -i switch. one is admin with privilege 15 and another is user with privilege 7.
but when we login from admin user it is not asking for enable password, it directly goes to privilege exc mode. i have set enable secret level 15 but its can' t work. so pleas guide me how set enable password for user who has privilege 15.
username user password 7 106
username Admin privilege 15 password 7 0123565B4846
ine con 0
line aux 0
line vty 0 4
transport input ssh
line vty 5 15
This is becuase " Level 15 is the level of access permitted by theenable password."
Try with below configuration.
aaa authentication login default group radius local
line vty 0 4
no login local
login authentication default
try this command along with your username and password.
Can you try using this commands?
S(config)#line vty 0 15
S(config-line)#priviledge level 0
I tested in my lab and it is working. Please share "Show Version" and full running configuration of the router.
It is what "Deepak" said. The enable mode gives you right to "level 15". If you try logging in the EXEC mode and check level; you will see "7 or 15" (depending on the credential you use)!!
hey mr. rajesh;
i think you din't get my question. please read this again. if you din't get this, tell me, i am try it an easy language. then please reply helpful suggestion. thank you.
hey Mr. rajesh;
i think you didn't get my question. please read this again. if you didn't get this, tell me, i am try it an easy language. then please reply helpful suggestion. thank you.