Training log buffer capability is not enabled yet.

[d.wingert]

Hello Netpro,

If I do a "show dsl int atm0" on a Cisco836 I get at the end of the output a line saying "Training log buffer capability is not enabled yet." Does anybody know what this means, and if this feature is of any use - how to activate it?

Regards, Dirk.

[#2]

after applying the command "dsl firmware secondary" this message should not be shown. check out the following link :

http://www.cisco.com/en/US/products/sw/iosswrel/ps5012/prod_release_note09186a008034d654.html#wp57305