Routing

We are going to setup multihoming for our internet connection. Our 1st provider assigned us our public IP. The external connection of our firewall has been configured for Port Address Translation. How can I configure our external router in order to u...

I'm revamping my companies network and was wondering if you guys could give me some advice on what equipment i need.company of 7 people. (software company)4-5 servers (2 public web servers)8-10 users.i mainly just need a router that i can do static r...

Hi there,One of my 2600 routers is being heavy over-utilizing. There is no QoS configured. I want to find out which host is eating up all the bandwidth? Thanks in advanced

We have a 2950C-24 Switch which restarted the other day unexpectedly. Apart from using the Show Version command to view the amount of 'Up Time' ... I don't know if there is a way to see WHY the switch may have restarted. I also used the Show Loggin...

Hi all 1. I'm not sure about the backup interface command , this command can use one interface on single router ? if i would like to use backup two interface it can't ??2. pls explain me about isdn bandwidth , i'm not sure it's 144 kbps or 192 kbps t...

Hello,I've plugged an E1 board (NM-1CE1T1-PRI) in slot 3 of my cisco 3640 (release 12)The board is shown as "unknown (type 925).I don't find any command to configure it..Can anybody help me pleaseThanksAnne

Hi everybody.Hi have some problems with connect two cisco routers between yourself with isdn bri leased line config is very simple.How can I do it ?there are a some config from routersfisrt router configisdn switch-type basic-net3isdn leased-line BR...

I have noticed a few of our staff gaining access to the p.c's at home using the the RDP function in XP. How do I block this from happening on our CISCO PIX 501.ThanksMark

How can I see what the light level (dB loss)is on an enhanced atm pa module on a Cisco 7304 router running 12.2 IOS. My carrier thinks the light level is not within the "acceptable" range.

Configuration: Cisco 1721 Series Router2 x 1-DSU-T1 V2 WICsNetgear Firewall connected to the LAN of the router.Symptons:One minute we can access outside sites and people outside can access ours, the next minute or few we can't access any outside site...

Hello,I need your help for a theoretical questionDoes the fragmentation a function in TCP and UDP like in IPAnd what is the difference between segmentation and fragmentationThank for your help.

I have tried to install the following configuration Cisco 2610 + VWIC-1MFT-E1 + AIM-VOICE-30.On www.cisco.com it is specified, that AIM-VOICE-30 works with 2610 router, but I have already tested it with two different Cisco 2610 routers. AIM-VOICE-30 ...

we are planning on adding a second ISP. I have a spare 3640 but it's been suggested that it may not be powerful enough or support enough memory. I don't know if it matters but the connections will be two T1 circuits from each provider.

I am experiencing file transfer timeouts when transferring a number of specific files from a range of external servers to all hosts on my network. When i try to transfer say file X from external site Y it will always timeout after transferring 'Z' am...