All I did before was simply copy the new .bin file to my CSR then change the "boot system" to the new version, then reboot the CSR. Do I have to do the steps from above link, such as "config-register", and "load from GRUB Mode"? are there any problem if I am just change the "boot system"?
Join us live on Tuesday, March 9 at 10 am PT (and on demand after) as we take a closer look at the WAN architecture innovations that Cisco has to offer.
We'll take your questions live during the broadcast (and after), so post them below in the comments.
Hello everybody,I am newbies with setting cisco switch.I downloaded Catalyst 2960-X Switch Getting Started Guide but I can't access to Device Manager - Express Setup according to guide.If you follow the instructions and try to keep all LEDs (exc...
To participate in this event, please use the button to ask your questions
Ask questions from Monday, March 8 to Friday, March 19, 2021
All the knowledge of these four experts at your disposal!
Cisco Software-Defined Wide Area Network (SD-WAN) provid...
Community Live- ISR1100X-4G and ISR1100X-6G Platform Overview and Architecture
(Live event - Tuesday, 23 March, 2021 at 10:00 am Pacific/ 1:00 pm Eastern / 7:00 pm Paris)-
This event will have place on Tuesday 23rd, March 2021 at 10:00 hrs PDT&...