Using CoPP in Packet Tracer
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-06-2024
10:42 PM
- last edited on
06-06-2024
10:43 PM
by
CiscoKoreaModer
Hello. I am using 2911 router on PKT and tried to use police to use Copp but there is no command, is it not possible to use CoPP on PKT?
- Labels:
-
Routing
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-06-2024 11:52 PM
Not Familiar with the tool checking the below document can be done - check if that help you :
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-07-2024 12:40 AM
Hello
Packet Tracer has limitations when it comes to advanced features like CoPP... GNS3, Cisco VIRL, or real hardware is recommended for that advanced config.
.ı|ı.ı|ı. If This Helps, Please Rate .ı|ı.ı|ı.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-07-2024 12:42 AM
Hello @cnsa
Packet Tracer has limitations when it comes to advanced features like CoPP... GNS3, Cisco VIRL, or real hardware is recommended for that advanced config.
