cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
245
Views
0
Helpful
4
Replies

Vlan command issues

sintel001
Level 1
Level 1

The exact commands given where

 

CMERouter1#config

CMERouter1(config) #interface vlan 1

                                                ^

% Invalid input detected at '^' marker.

 

The setup for the vlan database names worked fine but when I did a

CMERouter1(config) #interface ?    : there was everything but no vlan choice in the response

4 Replies 4

Sajid Ali
Level 1
Level 1

Hi Sintel0001,

Do you have any HWIC card at router?

 

Always rate helpfull posts

Sajid Ali Pathan

This discussion has been reposted from Cisco User Groups to the WAN, Routing and Switching community.

i've observed for quite some time now that some older posts are re-surfacing.

can CSC moderators do something about this?

John

 

I suspect that the CSC moderators are the ones who are causing this. It appears that a major cleanup is in process and posts are being moved to more appropriate forums. I agree that it is confusing when so many very old posts show up in the forum looking like new posts. I wish there were a way to silently move the old posts but I gather that this is not possible.

 

HTH

 

Rick

HTH

Rick
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: