03-18-2014 05:09 PM - edited 03-04-2019 10:36 PM
The exact commands given where
CMERouter1#config
CMERouter1(config) #interface vlan 1
^
% Invalid input detected at '^' marker.
The setup for the vlan database names worked fine but when I did a
CMERouter1(config) #interface ? : there was everything but no vlan choice in the response
03-19-2014 03:54 AM
Hi Sintel0001,
Do you have any HWIC card at router?
Always rate helpfull posts
Sajid Ali Pathan
08-03-2015 12:31 PM
This discussion has been reposted from Cisco User Groups to the WAN, Routing and Switching community.
08-04-2015 04:46 AM
i've observed for quite some time now that some older posts are re-surfacing.
can CSC moderators do something about this?
08-04-2015 06:43 AM
John
I suspect that the CSC moderators are the ones who are causing this. It appears that a major cleanup is in process and posts are being moved to more appropriate forums. I agree that it is confusing when so many very old posts show up in the forum looking like new posts. I wish there were a way to silently move the old posts but I gather that this is not possible.
HTH
Rick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: