10-05-2010 02:31 PM - edited 03-04-2019 10:00 AM
Hi,
I don't see the voice card ports even after configuring it as follow:
Router(config)#card type t1 0 0
SURWAN(config)#voice-card 0
Router(config-voicecard)#codec complexity high
Router(config-voicecard)#dspfarm
Router(config)#controller T1 0/0/0
Router(config-controller)#framing esf
Router(config-controller)#linecode b8zs
Router(config-controller)#ds0-group 1 timeslots 1-24 type e&m-wink-start
%Configure network-clock-participate wic 0 first
after above configuration I don't see voice ports as in following commands:
Router(config-controller)#do sh voice port sum
IN OUT
PORT CH SIG-TYPE ADMIN OPER STATUS STATUS EC
=============== == ============ ===== ==== ======== ======== ==
PWR FAILOVER PORT PSTN FAILOVER PORT
================= ==================
Router(config-controller)#exi
Router#sh ip int b
Interface IP-Address OK? Method Status Prot
ocol
GigabitEthernet0/0 10.10.10.1 YES NVRAM down down
GigabitEthernet0/1 unassigned YES NVRAM administratively down down
GigabitEthernet0/2 unassigned YES NVRAM administratively down down
Serial0/1/0 unassigned YES NVRAM administratively down down
Serial0/1/1 unassigned YES NVRAM administratively down down
Serial0/1/2 unassigned YES NVRAM administratively down down
Serial0/1/3 unassigned YES NVRAM administratively down down
Router#sh voice port sum
IN OUT
PORT CH SIG-TYPE ADMIN OPER STATUS STATUS EC
=============== == ============ ===== ==== ======== ======== ==
PWR FAILOVER PORT PSTN FAILOVER PORT
================= ==================
Please advise.
Thanks....
Solved! Go to Solution.
10-05-2010 02:46 PM
Hi,
I think the clue is right before our eyes:
Router(config-controller)#ds0-group 1 timeslots 1-24 type e&m-wink-start
%Configure network-clock-participate wic 0 first
You will need to add the network-clock-participate wic 0 global configuration command before entering the controller configuration and creating the timeslot groups.
Best regards,
Peter
10-05-2010 02:46 PM
Hi,
I think the clue is right before our eyes:
Router(config-controller)#ds0-group 1 timeslots 1-24 type e&m-wink-start
%Configure network-clock-participate wic 0 first
You will need to add the network-clock-participate wic 0 global configuration command before entering the controller configuration and creating the timeslot groups.
Best regards,
Peter
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide