01-24-2020 10:30 AM - edited 01-24-2020 10:41 AM
I was playing with network design in VIRL. What we have a MLS distribution pair that will eventually be connected to Meraki MX at the edge. I understand that Meraki MX uses VRRP to make HA pairs, so I was trying to simulate this in VIRL using iosv.
Given my lab configuration below, how would I implement VRRP between iosv-1 and iosv-2 to distribution? Is it not possible given they way I have setup the uplinks on the MLS? I feels like I must be missing something very basic. Does VRRP setup only exist on the internet edge of the Meraki MX?
01-24-2020 01:03 PM
If i understand correctly you Like to Deploy Meraki HA pair using VRRP.
You need to just extend the L2 for Meraki Device both the sides
here is example guide and setup :
https://documentation.meraki.com/MX/Networks_and_Routing/NAT_HA_Failover_Behavior
01-24-2020 03:01 PM
Hello
Not sure i understand- in you topology you show core1-2 is this to simulate a meraki HA pair? - if so then you don't require any first hop protocol in the assumption that the mx ha is performing the inter vlan routing ?
Would this be correct ?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: