cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
187
Views
0
Helpful
2
Replies
Highlighted
Beginner

VRRP setup :: Campus design with Meraki MX at edge

I was playing with network design in VIRL.  What we have a MLS distribution pair that will eventually be connected to Meraki MX at the edge.  I understand that Meraki MX uses VRRP to make HA pairs, so I was trying to simulate this in VIRL using iosv.

 

Given my lab configuration below, how would I implement VRRP between iosv-1 and iosv-2 to distribution?  Is it not possible given they way I have setup the uplinks on the MLS?  I feels like I must be missing something very basic.  Does VRRP setup only exist on the internet edge of the Meraki MX?

2 REPLIES 2
Highlighted
VIP Advisor

Re: VRRP setup :: Campus design with Meraki MX at edge

If i understand correctly you Like to Deploy Meraki HA pair using VRRP.

 

You need to just extend the L2 for Meraki Device both the sides

 

here is example guide and setup :

 

https://documentation.meraki.com/MX/Networks_and_Routing/NAT_HA_Failover_Behavior

BB
*** Rate All Helpful Responses ***
Highlighted
VIP Mentor

Re: VRRP setup :: Campus design with Meraki MX at edge

Hello 

Not sure i understand- in you topology you show core1-2 is this to simulate a meraki HA pair? - if so then you don't require any first hop protocol in the assumption that the mx ha is performing the inter vlan routing ?

Would this be correct ?



kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future
CreatePlease to create content