cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
460
Views
0
Helpful
4
Replies
Highlighted

VSS configuration on cisco 4507 R+E

Hello All

This is first time I am going to configure VSS , I learned some tips online, but most of them was 6500 series also I need experts advice that's why I am posting here.

Right now I have 2 brand new Cisco 4507 R+E , and Planning to configure VSS on it. hardware details are below.

NAME: "Switch System", DESCR: "Cisco Systems, Inc. WS-C4507R+E 7 slot switch "
PID: WS-C4507R+E       , VID: V09  , SN: FXS1937Q0ZE

NAME: "Linecard(slot 1)", DESCR: "1000BaseX (SFP) with 24 SFP Ports Jumbo Frame Support"
 --More--         PID: WS-X4724-SFP-E    , VID: V01  , SN: CAT1946L468

NAME: "Supervisor(slot 3)", DESCR: "Sup 8-E 10GE (SFP+), 1000BaseX (SFP) with 8 SFP+ Ports"
PID: WS-X45-SUP8-E     , VID: V05  , SN: CAT1947L0PP

NAME: "TenGigabitEthernet3/1", DESCR: "SFP-10Gbase-SR"
PID: SFP-10G-SR        , VID: V03  , SN: FNS19450B6N

  • please let me know the correct way to configure this series as vss,
  • do I need an ideal config on both switch (in case of power failure if other switch is working then I think its need same config as first) sorry may be I am confused by VSS and HSRP working.. :p.
  • How to connect any other L3 device connected to vss. By using L3 port channel?

Kindly make these confusion clear to me thanks .

Everyone's tags (3)
2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Community Legend

Luck is shining upon you.  

Luck is shining upon you.  

Sup8E means that you can enable Easy VSS.

Hall of Fame Community Legend

Let's say you have TWO WLC. 

Let's say you have TWO WLC. 

Connect WLC 1 straight to Unit 1 of the VSS.  Connect WLC 2 to Unit 2. 

The Cisco WLC supports HA SSO.

4 REPLIES 4
Hall of Fame Community Legend

Luck is shining upon you.  

Luck is shining upon you.  

Sup8E means that you can enable Easy VSS.

ohhh

ohhh

Thanks Leo for a quick response. going through this article :) .

 As I am new in VSS there is some confusion .

1-after VSS conversion, if I want to connect any L3 device suppose WLC, then do I need to connect WLC to both switch(Active & Standby) physically by using Multi chassis ether channel,

What if I will connect WLC to only active SWITCH, will it work after active switch fails  ?

Hall of Fame Community Legend

Let's say you have TWO WLC. 

Let's say you have TWO WLC. 

Connect WLC 1 straight to Unit 1 of the VSS.  Connect WLC 2 to Unit 2. 

The Cisco WLC supports HA SSO.

Hall of Fame Community Legend

Thank you very much for

Thank you very much for taking the time to rate our useful posts.  :)

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards