Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Don't miss this Cisco Catalyst 8000 offer

 
Labels

Forum Posts

I'm creating tunnel interfaces to support up to a potential number of 2000 end point terminations.  I have "heard" that there is an NHRP limitation of 254 per interface, but cannot find a specific reference.  Is this a real and hard limit? Does it de...

p-blalock by Level 1
  • 479 Views
  • 2 replies
  • 0 Helpful votes

I just deployed Microsofts direct access. Clients can get in no sweat, but with no internal v6 infrastructure we can't talk out to the clients. So I'm going to get a couple thousand /64 addresses. At this point we have a single internet connection, a...

My organization is presently using a pair of 1941 routers as our Internet gateways.  Each router is connected to a different ISP via gig0/1 and to a local switch via gig0/0. The routers are running BGP - each router peers with it's assigned ISP as we...

I ran the dynamic configurator for a 3925E and noticed it automatically included PI-MSE-PRMO-INSRT.  The output of the configuration shows this part as "New Product Hold until May 28, 2013".  What is this part number?Does this mean my 3925E will not ...

jkaras by Level 1
  • 44345 Views
  • 5 replies
  • 0 Helpful votes

Hi All, Our ISP had done the mapping for our private IP to their public ip on their end. When I configured this private IP for example 10.10.10.10 in a laptop and connected that to the internet connection then the public IP for example 30.30.30.30 i...

Good day! I've been messing with this configuration for about a week now and cannot figure out where the issue lies. Site A configured for a GRE tunnel to Site B at a remote location and working great. The issue is that I don't seem to be passing mu...

darron by Level 1
  • 587 Views
  • 4 replies
  • 0 Helpful votes

I am currently working on a solution for multiple sites that will have a Cradlepoint 4G modem as a failover in case their primary connection(Typically a DSL connection) goes down.We use a DMVPN hub to spoke connection to each location using either a ...

Running the following on 4321 Cisco IOS XE Software, Version 03.13.04.S - Extended Support ReleaseCisco IOS Software, ISR Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 15.4(3)S4, RELEASE SOFTWARE (fc3) Working on configuring netflow well flexib...

ALIAOF_ by Level 6
  • 3431 Views
  • 1 replies
  • 0 Helpful votes

Hi, I have a question about NTP. We want to setup our core switches as ntp master for our network. We have three data centers. Site A : Two Nexus as core Site B : two Nexus as core Site C : two 6800 (in VSS, so it's kind of one logical switch) as cor...

Vinny by Level 1
  • 326 Views
  • 1 replies
  • 0 Helpful votes