09-21-2016 09:10 PM - edited 03-05-2019 07:07 AM
Hello All
This is first time I am going to configure VSS , I learned some tips online, but most of them was 6500 series also I need experts advice that's why I am posting here.
Right now I have 2 brand new Cisco 4507 R+E , and Planning to configure VSS on it. hardware details are below.
NAME: "Switch System", DESCR: "Cisco Systems, Inc. WS-C4507R+E 7 slot switch "
PID: WS-C4507R+E , VID: V09 , SN: FXS1937Q0ZE
NAME: "Linecard(slot 1)", DESCR: "1000BaseX (SFP) with 24 SFP Ports Jumbo Frame Support"
--More-- PID: WS-X4724-SFP-E , VID: V01 , SN: CAT1946L468
NAME: "Supervisor(slot 3)", DESCR: "Sup 8-E 10GE (SFP+), 1000BaseX (SFP) with 8 SFP+ Ports"
PID: WS-X45-SUP8-E , VID: V05 , SN: CAT1947L0PP
NAME: "TenGigabitEthernet3/1", DESCR: "SFP-10Gbase-SR"
PID: SFP-10G-SR , VID: V03 , SN: FNS19450B6N
Kindly make these confusion clear to me thanks .
Solved! Go to Solution.
09-21-2016 09:21 PM
09-21-2016 09:55 PM
Let's say you have TWO WLC.
Connect WLC 1 straight to Unit 1 of the VSS. Connect WLC 2 to Unit 2.
The Cisco WLC supports HA SSO.
09-21-2016 09:21 PM
Luck is shining upon you.
Sup8E means that you can enable Easy VSS.
09-21-2016 09:49 PM
ohhh
Thanks Leo for a quick response. going through this article :) .
As I am new in VSS there is some confusion .
1-after VSS conversion, if I want to connect any L3 device suppose WLC, then do I need to connect WLC to both switch(Active & Standby) physically by using Multi chassis ether channel,
What if I will connect WLC to only active SWITCH, will it work after active switch fails ?
09-21-2016 09:55 PM
Let's say you have TWO WLC.
Connect WLC 1 straight to Unit 1 of the VSS. Connect WLC 2 to Unit 2.
The Cisco WLC supports HA SSO.
09-21-2016 10:34 PM
Thank you very much for taking the time to rate our useful posts. :)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide