cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1493
Views
0
Helpful
2
Replies

VWIC2-1MFT-G703 in Cisco 2921 router

ciscoroyzhang
Level 1
Level 1

                   Hi there,   I have installed a VWIC2-1MFT-G703 module into cisco 2921 router, I can verify the card by show inventory command. but in show run, I do not see the E1 controller card there. this card is used for TPG lease line for data only.  Can some advice if those card is compatable with new 2921 router?  or need some extra command to bring it up?  many thanks in advance.  Roy

1 Accepted Solution

Accepted Solutions

paolo bevilacqua
Hall of Fame
Hall of Fame

Configure card-type.

View solution in original post

2 Replies 2

paolo bevilacqua
Hall of Fame
Hall of Fame

Configure card-type.

thanks, Paolo,   I thougt  card-type only needed on E1/T1 card, seem to me I am wrong with 2921. it worked.  many thanks. R

Review Cisco Networking for a $25 gift card