VWIC2-1MFT-G703 in Cisco 2921 router

[ciscoroyzhang]

                   Hi there,   I have installed a VWIC2-1MFT-G703 module into cisco 2921 router, I can verify the card by show inventory command. but in show run, I do not see the E1 controller card there. this card is used for TPG lease line for data only.  Can some advice if those card is compatable with new 2921 router?  or need some extra command to bring it up?  many thanks in advance.  Roy

[paolo bevilacqua · Accepted solution]

Configure card-type.

[ciscoroyzhang]

thanks, Paolo,   I thougt  card-type only needed on E1/T1 card, seem to me I am wrong with 2921. it worked.  many thanks. R