02-08-2012 05:19 AM - edited 03-04-2019 03:10 PM
Dear All
I know who can help me to configure my cisco 892 router
want a static ip address assigned to the interface because
and I have no more internet on the router
because am working on my network academy for CCENT
Please help!
02-08-2012 05:38 AM
Hi,
interface x/x
ip address x.x.x.x y.y.y.y where x.x.x.x is the IP and y.y.y.y is the subnet mask
no shut
Regards.
Alain
02-08-2012 05:49 AM
okay I did
but can not connect to the Internet
02-08-2012 05:51 AM
Do you have a default gateway pointing at the next hop router towards your ISP?
02-08-2012 05:56 AM
yes I did make that can not connect to the Internet ?
02-08-2012 06:01 AM
Hi,
From where can't you connect and how do you test connectivity?
Post your config and by the way you said you didn't have internet anymore in your first post and now you say you can't connect to internet ?
Regards.
Alain
02-08-2012 06:21 AM
02-08-2012 06:40 AM
Hi,
is there a modem connected to Gigabit 0/0 ?
Can you ping 8.8.8.8 from the router ? if so can you ping 8.8.8.8 from a wired client getting a dhcp address?
Regards.
Alain.
02-08-2012 07:06 AM
02-08-2012 07:17 AM
Hi,
you didn't answer this:
Can you ping 8.8.8.8 from the router ? if so can you ping 8.8.8.8 from a wired client?
if not verify NAT is working: sh ip nat translation
Regards.
Alain.
02-08-2012 07:31 AM
02-08-2012 07:44 AM
Hi,
access-list 199 permit icmp any any
no service timestamp debug
logging console debug
do debug ip packet detail 199
do ping 84.197.160.1 rep 2
Post the output of the debug
Regards.
Alain
02-08-2012 09:53 AM
02-08-2012 10:08 AM
To direct traffic as you are suggesting you need an exit interface to send the traffic to.
If you are sitting on FastEthernet 0/0 with an IP of 10.0.0.1 255.255.255.0
You will need an exit interface such as FastEthernet 0/1 with an IP address of 192.168.0.1 255.255.255.0
You would then create a static route like ip route 0.0.0.0 0.0.0.0 FastEthernet 0/1 (or you need a next hop address which would be the far end on the other side of the exit interface)
This will take all traffic and send it out FastEthernet 0/1
This is just an example. To customize for you we need to know some more specifics on what you are trying to do.
02-08-2012 03:29 PM
Maybe if you remove the default gateway and put default static pointing to the default gateway.
ip route 0.0.0.0 0.0.0.0 84.x.x.x
Hope this helps
Eugen
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide