cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1568
Views
0
Helpful
28
Replies

WAN static no ISP

pcfreak49
Beginner
Beginner

Dear All

I know who can help me to configure my cisco 892 router

want a static ip address assigned to the interface because

and I have no more internet on the router

because am working on my network academy for CCENT

Please help!

28 Replies 28

cadet alain
Mentor
Mentor

Hi,

interface x/x

ip address x.x.x.x y.y.y.y      where x.x.x.x is the IP and y.y.y.y is the subnet mask

no shut

Regards.

Alain

Don't forget to rate helpful posts.

okay I did
but can not connect to the Internet

Do you have a default gateway pointing at the next hop router towards your ISP?

yes I did make that can not connect to the Internet ?

Hi,

From where can't you connect and how do you test connectivity?

Post your config and by the way you said you didn't have internet anymore in your first post and now you say you can't connect to internet ?

Regards.

Alain

Don't forget to rate helpful posts.

no I can not connect to the Internet

This is the running-config

Hi,

is there a modem connected to Gigabit 0/0 ?

Can you ping 8.8.8.8 from the router ? if so can you  ping 8.8.8.8 from a wired client getting a dhcp address?

Regards.

Alain.

Don't forget to rate helpful posts.

yes the Gigabit 0/0 is connected to the modem

and the wired client, you get a dhcp

these are the data wired client

and can ping the router to 10.10.10.1

Hi,

you didn't answer this:

Can you ping 8.8.8.8 from the router ? if so can you  ping 8.8.8.8 from a wired client?

if not verify NAT is working: sh ip nat translation

Regards.

Alain.

Don't forget to rate helpful posts.

no I can not ping from the router to 8.8.8.8

nor from the wired client PC to 8.8.8.8
This configuration is NAT

Hi,

access-list 199 permit icmp any any

no service timestamp debug

logging console debug

do debug ip packet detail 199

do ping 84.197.160.1 rep 2

Post the output of the debug

Regards.

Alain

Don't forget to rate helpful posts.

I did that and this is the output

Rick Morris
Frequent Contributor
Frequent Contributor

To direct traffic as you are suggesting you need an exit interface to send the traffic to.

If you are sitting on FastEthernet 0/0 with an IP of 10.0.0.1 255.255.255.0

You will need an exit interface such as FastEthernet 0/1 with an IP address of 192.168.0.1 255.255.255.0

You would then create a static route like ip route 0.0.0.0 0.0.0.0 FastEthernet 0/1  (or you need a next hop address which would be the far end on the other side of the exit interface)

This will take all traffic and send it out FastEthernet 0/1

This is just an example.  To customize for you we need to know some more specifics on what you are trying to do.

ebarticel
Enthusiast
Enthusiast

Maybe if you remove the default gateway and put default static pointing to the default gateway.

ip route 0.0.0.0 0.0.0.0 84.x.x.x

Hope this helps

Eugen

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers