- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-01-2011 01:27 PM - edited 03-04-2019 11:36 AM
I have a CISCO 1700 series router and I would like to remove the CSU/DSU WIC & add a WIC-1ENET is this possiable without having to upgrade the IOS Firmware.
Solved! Go to Solution.
- Labels:
-
Other Routing
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-01-2011 01:37 PM
Please check the link for software requirements:
http://www.cisco.com/en/US/docs/routers/access/1700/software/feature/guide/cn1ENET.html#wp1003555
If the software supports the WIC there shd be no other issues.
Regards,
Subramaniya Karthic
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-01-2011 01:55 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-01-2011 01:37 PM
Please check the link for software requirements:
http://www.cisco.com/en/US/docs/routers/access/1700/software/feature/guide/cn1ENET.html#wp1003555
If the software supports the WIC there shd be no other issues.
Regards,
Subramaniya Karthic
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-01-2011 01:52 PM
Thanks so much when I get back to my lab I will check the version. Thanks again so much.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-01-2011 01:55 PM
Please rate posts if it was helpful.
Thank you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-01-2011 03:18 PM
Where do you rate at.
