- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-08-2024 10:49 AM
Hello.
I always get useful information from community.
Can I configure "bandwidth" command for cEdge router via template ?
Ex)
Interface GigabitEthernet1
bandwidth 5000 # Possible to config this through device/feature template ?
Thank you.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-08-2024 12:01 PM
If this is managed by vManager (not cli template)
then suggest to use QoS :
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-08-2024 12:01 PM
If this is managed by vManager (not cli template)
then suggest to use QoS :
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-10-2024 03:59 AM
Thank you so much for your solution.
