cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
458
Views
1
Helpful
3
Replies

Pushing vEdge list from vManage to vBond/vSmart fails

bmcgahan
Level 1
Level 1

I have an SD-WAN test lab environment in EVE-NG where I'm hosting the vManage, vSmart, & vBond, along with various vEdge & cEdge routers.

I'm running into some strange issues where the vEdges do form tunnels to each other, I am able to ping site-to-site, but the vManage is complaining that the devices are out of sync. I don't have any templates configured yet or any type of policies, just a very basic config of full mesh for Service VPN 1.

Attached is the specific error message. Any ideas what this means? 

The vManage, vBond, and vSmart all have "allow-service all" on their sdwan tunnel interfaces, so netconf should be permitted.

 

Thanks!

 

 

1 Accepted Solution

Accepted Solutions

They did have that command. I ended up just restarting the topology and it magically worked  

Thanks!

View solution in original post

3 Replies 3

balaji.bandi
Hall of Fame
Hall of Fame

Make sure the vBond and vSmart configured correctly  - allow-service netconf

check my lab  reference :

https://www.balajibandi.com/?p=2028

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

They did have that command. I ended up just restarting the topology and it magically worked  

Thanks!

show sdwan control-connections

share from vmanage

HTH,
Please rate and mark as an accepted solution if you have found any of the information provided useful.