We have a site that has undergone a total re-up. All new policies were pushed by CSM but the actual physical IP on the device was updated via CLI as I cannot find a way to do this using CSM without loosing connection. I've been advised that after doing this if you update the interface IP and then management IP in the device credentials that I will be able to reconnect but this isn't the case. If I test connectivity to the device it times out each time now. There are no reach ability problems. Is there something I'm missing here or is there a better way to do this in future?
Microsoft published a security advisory providing guidance to increase the security for communications between LDAP clients and Active Directory domain controllers. The document introduced the use of LDAP channel binding and ...
view more
Hi, Hoping someone can help. I am getting the following error message when trying to connect to Cisco any connect: Cisco connection attempt has failed due to network or PC issue.Does anyone know how to solve this issue?
Dear all,can you please share, based on your experience, how should looks like an Endpoint Purge Policy? I would like to Purge all the Endpoints that didn't authenticate during the last 6 months, for example. Thanks,M.
Hello Support,Due to a vulnerability, i have to upgrade the two FMCs i have( one FMCv(6.2.3.12) and FMC 1000(6.3.0.3)).The target version i have to go is 6.4.0.7 for both.The devices which manage the FMCv(6.2.3.12) are two sfr modules of 6.2.3.12 and a FT...
view more
Hello Support,Due to a vulnerability, i have to upgrade the two FMCs i have( one FMCv(6.2.3.12) and FMC 1000(6.3.0.3)).The target version i have to go is 6.4.0.7 for both.The devices which manage the FMCv(6.2.3.12) are two sfr modules of 6.2.3.12 and a FT...
view more
