Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been asked to look at re-routing inbound calls from certain numbers via the local CUBE. 90% of calls come in and route normally, but there are a handful that no matter who is being called the call should go to a specific user.
I've found exa...
Working on a set of firewalls that are being migrated from ASAs to FTDs (3 sets of HA clusters). All 3 sets have OSPF configured, with 2 of them "default-information originate". The 3rd has this for it's OSPF configuration on the ASA:
prefix-list S...
Currently have a 4331 that is supporting an on-prem cluster of CUCM. Working on migrating users to WebEx calling, w/ the plan to still utilize the local 4331 for calling in/out. The plan is to do a phased migration, so I wanted to confirm that this...
Currently have a 9800-40 w/ 100 APs associated and working as expected. The self-signed certificate used for AP Join is expiring next month and wanted to work on getting it renewed and replaced prior so as to not have any issues. I was reading this ...
Currently have a SIP trunk that requires authentication w/ ITSP. My sip-ua section is as follows:
sip-ua
credentials number AAAAAA username AAAAAA password 7 mypassword2 realm myitsp.net
authentication username AAAAAA password 7 mypassword
retry i...
Thanks for the reply. Yes, had been using combined dial-peers. I was able to do some preliminary testing Friday using the provision policy on dial-peer 200 and modifying dial-peer 401:voice class dial-peer provision-policy 200
preference 1 calling...
I'd have to 100% agree on that 1. I've definitely found solutions to other issues I've come across after reading some of @Roger Kallberg posts to other threads in the community.
Thanks for the detailed reply. It's been a while since I used COR lists so I'll have to review it to make sure I fully understand it before attempting to implement it. Should have some feedback in the morning.
Thanks. I wasn't worried about the pattern-map number being the same.I was concerned that the .T would effectively match calls from the PSTN and also match calls from CUCM users so then wouldn't get routed out the correct dial-peer facing the ITSP. ...