adding "Hex Path Identifier" to Cisco Channel Interface

[fmasson]

Hi,

does anyone know a scenario to add additional "hex path identifier" to cisco channel interface (IP Hst Backup Group) without negating the complete Group?

i.e. existing is: path d850 1690

trying to override results in the following:

...(config-if)#path D850 1690 db50

%path D850 1690 DB50

conflicts with

path D850 1690

Negating the complete statement will "drop" all the connections.

regards

Frank

[umedryk]

cipCardClawConfigPath specifies the Hex path identifier for the switch port containing the fiber from the channel on the host to which this task connects. This is a concatenation of the switch port number, the channel logical address, and the control unit logical address.