Server Networking

Hi,we are doing some staging activities, Both 4492 Gss are connected in the same vlan ,one configured as primary and other standby, both are communicating each other, when we down the primary GSS ,standby is not becoming active .How can we achieve th...

Hi all,i have two GSS 4490 series...one is configured as GGSM Pri and the other as GSSM sec.However when the pri goes down(simulated by taking down the link) the sec is not taking over as the primary... the sec gss status still shows as standby.Is th...

Is Infiniband a parallel technology to Ethernet to use with IP or is it a SAN interconnect for storage? Or can it be used in both scenarios?The last time I checked there was 10 Gbps Ethernet available over copper. What's the maximum bandwidth availab...

I'm looking to use a RPS 2300 to act as a redundant power supply for some 2950 switches in my data center. I figured that they would be able to keep my 4 switches up and running in the event that power was lost to the switches. As long as I have my...

I have a basic CSM setup where 2 servers are load balanced accross a CSM. How would I disable anything other than established connections for going out of the servers through the CSM's? The servers are externally managed where incoming loadbalanced (...

Dear alli have datacenter with web server runs IISits about 2000 session same time on web server and this is main reason that my IIS server stops working while the server performance is acceptabeldoes cisco has any device for limiting session in same...

I think I posted this onto the wrong Forum. Anyone able to advise here?SteveK.Posted by: stevek1 - Network Administrator, Dept Natural Resources and Mines Apr 18, 2008, 12:04am PSTHi Folks, I need to provide internal devices with active-active acces...

Hello,We are using CSM-S, but in one particular application SSL has to be terminated on the servers, not the SSL daughter card. What would be the best way to keep stickiness in this case? Tried using SSL-ID, but it still drops the session once in a w...

I have an SDLC-attached FEP, and I am doing reverse-media translation to the secondary which is on a remote token-ring LAN.Whenever they bounced the FEP port, it takes 15 minutes or so to recover. Is there a timer or other setting I need to configur...

I have chosen this the Data Center form to post this question, since they are the most who deal with partitioning and virtualization.I was expecting Cisco will consider bringing partitioning to their next coming Edge router similar to Juniper-SSG ser...

HI All,i've got big headache....this error message on "Application and Content Networking System Software Release 5.2.9 (build b5 Dec 29 2005)" cisco CE :)error is:Manifest Parse Errors----------------------- Manifest Parser Error(701):Process...

Does any one know if there is any document available for planning and architecturing server farms switching infrastructure?thanks,Fawad

;

What is the difference between these commands?"sdlc role secondary"and "sdlc address c1 seconly"If you understand the difference, please respond and help me understand. I'm interpreting the (vague) documentation as saying these both do the same thin...