Server Networking

I have two Nexus 9372PX's and just purchased two FEX C2348TQ's. When I attempt to configure a Nexus for a FEX I'm receiving the following output from the show fex detail command: ANC-NEXUS-9372-2(config-if-range)# sh fex 102 detailFEX: 102 Descriptio...

Hello, I am looking for clarification about when do I configured bridged vlan netflow (on vlan configuration) vs configuring interface vlan netflow? For example, when should I use: vlan configuration 10 ip flow monitor flmonitor1 input or: interface ...

Hi  I was wondering if it was possible to terminate a VXLAN from a Nexus 5672 to VTEP that was vSphere. If so, how can it be done?

I bought a N9K-C9372PX-E= by mistake. It is similar to N9K-C9372PX-E (without "=") ,  because the the first one (with "=") is a spare, that does not include installation kit, power supply or fans. I am buying those 3 parts, buy I want to check if I n...

Hi, Our vASR is up&running in a KVM/libvirt VM, but one of our VLAN interfaces is not working. This is the first time we use an ASR. Which is the difference that could render the one having 192.168.2.5 IP (VLAN 2044) not working while 192.168.0.199 (...

I am new on nexus. trying to configure NTP on  Nexus 1110-S . and it is not syncing. ntp server 192.168.1.17ntp server 192.168.218ntp source 192.168.99.168 nexus1110S# sh ntp peer-statusTotal peers : 2* - selected for sync, + -  peer mode(active),- -...

Hi All,I am very novice in Cisco.In our office using Catalyst 3750 two switch.Stack power and Stack data are connected.In the Switch LED indicator, S-PWR LED green blinking. (Normal condition will Green LED) When we figure out there will Stack power ...

Hello, i need a solution. The design of the network is shown in the attachment. I have two Nexus 7K as "core" with about 50 interface vlans ( ipv4 and some ipv6 ) and HSRP up and running. All internal traffis is routed by the 7K's without problems. A...

I'm experimenting with VLAN tagging at the server level. One thing I was curious about was setting all ports on a switch to a TRUNK port to allow the server to designate which Tag to assign to the packet. When I do this no VLAN will come up unless I ...

Question about this service and all the other services: What each service is responsible for?sh processes log Process          PID     Normal-exit  Stack  Core   Log-create-time---------------  ------  -----------  -----  -----  ---------------snmpd ...

I'm running a cloud-datacenter that currently consists of two ASA-5515's running ASA912-smp-k8.  I'm limited by the amount of information I can provide, so I won't be posting the running config.  Long story short, we have 2 clients running cisco equi...

My team's Cisco IMC Supervisor keeps stalling at the "Inventory Collection in progress" phase. When I've used it in the past, this only takes about 10-15 min. Also, the "Last Inventory Update" was 4 months ago. Anyone have a similar problem or a solu...

Hi all, I have a Nexus 5548UP and a 2232TM-E, what type of sfp should I use to connect them? because I have the FT-10g and not working. Any doc where I can see this? thanks!. 377