01-24-2018 04:33 AM - edited 03-01-2019 01:42 PM
PID: N3K-C3064PQ-10GE , VID: V01
switch# show system resources
Load average: 1 minute: 1.34 5 minutes: 1.34 15 minutes: 1.34
Processes : 613 total, 1 running
CPU states : 13.0% user, 6.5% kernel, 80.5% idle
CPU0 states : 15.0% user, 6.0% kernel, 79.0% idle
CPU1 states : 11.0% user, 7.0% kernel, 82.0% idle
Memory usage: 3785024K total, 2506784K used, 1278240K free
Software:
kickstart image file is: bootflash:///n3000-uk9-kickstart.6.0.2.U3.8.bin
system image file is: bootflash:///n3000-uk9.6.0.2.U3.8.bin
Error Message :
switch# copy running-config startup-config
[####################################### ] 97%
copy failed at 97%, just hang, no error message, no progress. I tried changing IOS, but found same problem, any suggestion ?
Tried to copy running config to tftp server, found same problem, no luck.
01-24-2018 10:51 AM
01-25-2018 02:06 PM
We reloaded it so many times, no luck.
01-25-2018 02:10 PM
Time to call TAC.
01-27-2018 03:21 AM
We don't have any agreement with cisco, can we still use TAC ?
01-27-2018 12:00 PM
Are the devices covered under smartnet?
01-29-2018 04:45 AM
We don't have smartnet, I am afraid.
01-29-2018 10:11 AM
Okay, this is what I would do.
First issue the command "no debug all", second issue the command "clear logging ip access-list cache", reload the switch and try again.
If that doesn't work do the following..
During your next maintenance windows save your config off the switch to you computer, upgrade the switch to NX-OS version to at least Release 7.0(3)I6(1), final step unplug the switch and leave unplugged for around 5 min. Plug back in and load the running config if necessary.
For grins and giggles can you send the output from the following...
"show system resources"
Hope this helps.
02-01-2018 02:17 AM - edited 02-01-2018 02:19 AM
oftware
BIOS: version 3.9.0
NXOS: version 7.0(3)I4(3)
BIOS compile time: 01/25/2016
NXOS image file is: bootflash:///nxos.7.0.3.I4.3.bin
NXOS compile time: 9/2/2016 3:00:00 [09/02/2016 11:19:13]
We can copy run start without any configuration, but once we configure copy run start doesn't work.
Still same problem...
02-01-2018 10:07 AM
02-01-2018 11:21 AM
We already did it, without any configuration it does work, once we configure and connect it to the network, it doesn't work.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide