I had same problem with my VEM not showing in VSM when I did Show Module. I created a Physical Adapter and linked a physical port on a physical switch to this adapter. So, I have two links to my ESX host. vEthernet0 is linked to vSwitch and vEthernet1 is linked to Physical Adapter I created. I have Layer 2 configuration. After doing this I was fine. I hope this makes sense.
Cisco Data Center Networking Demo Series – Assurance and Insights
Live webinar: Cisco Data Center Networking Demo Series – Assurance and InsightsThursday, August 27, 202010:00 AM Pacific Standard Time (San Francisco, GTM -08:00)
With Cisco Data Cen...
The Future of Fast: Introducing Nexus 3550 Series and Nexus SmartNICs
Network Insider Live Webinar
Tuesday, August 25, 202010:00 am Pacific Time(San Francisco, GMT-08:00)
The Nexus 3550 Series and Nexus SmartNIC technology, formerly Exablaze...
Original Blog published @ https://blogs.cisco.com/datacenter/spinning-up-an-nvme-over-fibre-channel-strategy
Every so often there comes a time when we witness a major shift in the networking industry that fundamentally changes the landscap...
Let me start by telling you that there is already a very nice document in the Cisco Community Forums which describes the procedure to upgrade the APIC CIMC. In case you came across this document before looking into the mentioned one, here is...