sample config for local switching of QLLC to Ethernet?

fmasson · ‎07-02-2003

is it possible to switch a serial attached controller (PU2.0/2.1) over X.25 QLLC to a local attached Mainframe by ethernet?

owillins · ‎07-08-2003

We used Frame Relay across the WAN instead of X.25 and there were no problems with the implemetation. Guess it would work with X.25 too. The following doc gives you the configuration.

http://www.cisco.com/warp/customer/488/48.html

fmasson · ‎07-08-2003

i know this example config, but i'm searching fo an example where the Mainframe is on the "Ethernet" side where and the PU2.x are at the x25 ones.