Hi! We have:
- servers UCSX-210C-M6
- chassis UCSX-9508
- fabric UCS-FI-6454
We plan to deploy a cluster based on vSphere. What are the best practices network configuration for this type of equipment? Below is an example
1 variant
Example, for Management create one vNIC adapters, turn on Failover. Perform the following setting in vCenter:
2 variant
Example, for Management create two vNIC adapters, turn off Failover. Perform the following setting in vCenter:
Is it possible to implement balancing through the fabric so that two adapters are active?
Do I need to create a separate virtual switch for each service? e.g. vMotion, Management, Provision, VMs
1 Accepted Solution