cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
916
Views
0
Helpful
1
Replies

USC-X: network configuration

Anton88
Level 1
Level 1

Hi! We have:
- servers UCSX-210C-M6
- chassis UCSX-9508
- fabric UCS-FI-6454
We plan to deploy a cluster based on vSphere. What are the best practices network configuration for this type of equipment? Below is an example
1 variant
Example, for Management create one vNIC adapters, turn on Failover. Perform the following setting in vCenter:

1 variant.png

2 variant
Example, for Management create two vNIC adapters, turn off Failover. Perform the following setting in vCenter:

2 variant.png

Is it possible to implement balancing through the fabric so that two adapters are active?
Do I need to create a separate virtual switch for each service? e.g. vMotion, Management, Provision, VMs

1 Accepted Solution

Accepted Solutions