04-10-2013 04:03 AM
I can access the web console, and also have telnet access but only to a VT100 menu system - How do I access the full console command prompt (without using the serial console connection)?
...Jon.
04-16-2013 10:06 AM
Hi Basiluk11, thank you for using our forum, my name is Johnnatan I am part of the Small business Support community. I found information regarding console that could help you, http://www.voipsupply.com/downloads/dl/file/id/166/cisco_esw_500_series_admin_guide.pdf in "using the Switch Console Port section."However as far I know you need the serial console connection.
I hope you find this answer useful
“Please rate useful posts so other users can benefit from it”
Greetings,
Johnnatan Rodriguez Miranda.
Cisco Network Support Engineer.
04-17-2013 01:32 AM
This is more a question about how to access the command line interface within the console - I can telnet to the box, but onlt get presented with a very basic menu system.
04-17-2013 01:47 PM
Hi Basil, this device does not support a CLI.
-Tom
Please mark answered for helpful posts
04-18-2013 06:39 AM
Thnks for the information Tom
“Please rate useful posts so other users can benefit from it”
Greetings,
Johnnatan Rodriguez Miranda.
Cisco Network Support Engineer.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide