Switches - Small Business

I am setting up a 3 host ESXi cluster. I am using a pair of stacked SG500-28 switches for switching redundancy. Each host has 8 NICs. 4 to each switch. I have successfully setup a 3 NIC LAG with 1 path to one switch and 2 paths to the other. These LA...

In troubleshooting another issue I set up another SG300 on the same VLAN as my SG300-28P and then setup a Monitor Port on it to see what Broadcasts I was getting.Low and behold the SG300-28P is sending out quite a few Broadcast Packets. Most of them ...

Hello,I'm used to using full blown cisco IOS/CLi and I'm new to the SG 300 switches.Can someone please tell me how you can default a port config?The 'default int ##' command doesn't exist on the CLi and I can't find anywhere in the web gui for this.F...

Hi,I will like to set auto baud for the SG500. By default its 115200bps.I had tried the following methods:1) switch xxxxx (config)# line console    switch xxxxx (config-line)# autobaud  --------------------> my terminal hangs and print out rubbish2) ...

Hi Cisco support,I have 10 pcs of Cisco SF300-24P but i have strange problem im not sure if this bug or not. i completely update the firmware from Version 1.0.0.27 to 1.1.2.0 i found too annoying thing you cannot assign VLAN ID in interface managemen...

Hello,I'm having a problem.I can not access the switch through the console. The web interface is working properly.Model: SRW224g4Below some pictures.The HyperTerminal settingserror:If anyone can help me?Thank you and excuse the bad English.

                   I need a little guidance. Trying to connect SG500X-24 switches to a new installation of MOE (four sites)provided by Century Link.  Anyone have any experience with this?  I have tagged the uplink port with the MOE vlan, but traffic ...

Hey,We are looking for a power adaptor for a cisco switch Sf302-08p. We can't find the adaptor anymore and we have to orde a new one, but we can't figure out the order number of the adaptor. The voltages is 48vdc and has an 4 pin connector . Do someo...

Hello,I just introduced a Cisco SP200-48P switch into our Nortel environment. When I plug the phone into a POE port, the port is unresponsive (doesn't light up), and the Nortel phone doesn't power up.The data aspect of the port is fine, when I plug a...