I need to reset webUI admin user, via CLI on CSPC 2.10 - doable ?

[mbilgrav]

I just redeployed 2.10 VM on Hyper-v ... it took ages to complete

Now I need  to reset webUI admin user, via CLI on CSPC 2.10 - doable ?

Someone other than med sat the initialt password, as Im meet with a login but not a pw create login
I have full access ti SSH-admin / collector / root

Please provide steps to reset webUI-Admin via CLI

my CCO Id

[balaji.bandi]

SSH to CSPC - console access.

#passwd admin

Enter new password - is this works ?

[mbilgrav]

Thanks for your reply.

I do believe that is the way for changning admin user password, for the CLI admin.
My issue is with the webUI admin user - Not the CLI user.
Theses two credentials are not the same, beside the collision of username.

[dbourai]

Hello,

Good day to you!

I have acknowledged this post.

Please let us know your next best availability so we can troubleshoot further.

Please share your email over the personal message.

Thanks & regards,
Devashish Bourai.

[mbilgrav]

thx!
and Done

[dbourai]

Hello,

Following is the resolution for this post - 

The customer had to access cspc GUI. 

Security questions were set successfully. The customer was able to access the GUI successfully. 

Thanks and regards, 

Devashish Bourai. 

[b.prajapati1]

Hi I have the same issues and need to Reset CSPC GUI password from CLI (I have full access to CLI root, collectorlogin and admin) please can you post the relevant commands

Thanks

Bhaves