Software-Defined Access (SD-Access)

hi Gents anyone here to give a clue how do we make subject? according to amazing hint from Assurance deployment guide " Note  For a link to be considered a WAN link, you must manually assign the system-generated WAN tag to the required port. See "Ass...

We are implementing a SD-Access greenfield using LISP Pub/Sub for SD-Access transit.  We have two data centers each with an internet egress point through a firewall located at each site.  Apart from a youtube video (which is good) I have not been abl...

So we currently run CC 2.3.5.6 with a fully integrated ISE 3.0 and we use policy set for Wired+Wireless Authentication and have 3 VNs in SDA with multiple hierarchical L2 VN/AnyCast Gateways and associated IP Pools in CC. Simply put: depending on MAC...

Hi,in this document , it says that in case of External+Internal border where BGP is imported into LISP and LISP is redistributed back into BGP, tags are needed to prevent iBGP to LISP route imports and hence avoid potential loops.Can someone, please,...

Hi Cisco Community   We have used some C3560CX as office extenders and now want to activate SGT.  Unfortunately this does not work and we do not yet understand the reasons. A new C9200CX works perfectly.   There are contradictory announcements and ma...

Hi All, Hope you’re doing well!   Just one small question – if MACsec support is on the roadmap for SD-Access? Or there are no plans to support it at all?   Any input would be very welcome

Hello, I have a physical Cisco DNAC appliance, and I’ve set up EVE-NG on ESXi to practice SD-Access. I’m a bit confused about which Cisco switch IOS images are compatible with EVE-NG for SD-Access lab simulations. I want to ensure I use the right ima...

We’re working on a greenfield deployment of Cisco SD-Access. We have two Catalyst 9600R switches designated as BN/CP, which we’re setting up as individual devices. Many recommended avoid using VSS or SVL due to downtime during maintenance windows Eac...