Software-Defined Access (SD-Access)

We are getting thousands of email alerts from DNAC in a day. Is there a way to suppress user connected interface up down alerts. This is getting mixed up with actual device connected interface up down alerts. 

HiI'm testing LAN Automation.  Specifically I want to pre-import a list of devices and their serial numbers so that they are named correctly during discovery. In the session attributes section of LAN Automation there is a Hostname mapping area and it...

Hello All,I'm reaching out to see if anyone has experienced any issues with Catalyst 9136 APs in Fabric Wireless mode. We have been using SDA with eWLCs for about two years. So far our most stable codebase has been 17.6.2 through 17.6.4, with most of...

Hello community, Do you know if it is possible to have a SSO cluster between 2 border nodes having also WLC role ? I think it is not possible and there's no other choice than having them in N+1 scenario. Also, if N+1 scenario, the only way to keep th...

Hello,  We have installed two new switches (5&6) on an existing Fabric Stack Edge (4 switches), we can see all the S/N on the DNAC Inventory, but device-tracking configuration is not applied on all new ports/switches.  SW-WTCP3-NT-S-1#show switch det...

HiWe are full SD Access at work now and I was wondering could I manage a device via DNAC that isnt part of the Fabric on a site? So I want to install a 2 Switch stack in our DMZ I'm wondering if this is possible then maybe I could still use DNAC to k...

HiCan ayone explain and add link on how to set up DNAC/ISE Intergration and what technoligies are used,??  (is the intergration Cert based) ??.Thanks

Hi, We are implementing our new SDA network We have an issue for the ip phones registration that it takes a very long time to register to CUCM [about 55 minutes] When it connected, it got ip address from infoblox, then it send request to CUCM untill...